T-DRILL HFT-2000 Manifold Fabricating Machine
Semiautomatic unit for small volume production of T-DRILL collars
T-DRILL HFT-2000 feed table is a manually operated device to be used in
conjunction with T-DRILL T-35 or T-60 collaring machines. Also collaring of
stainless steel is possible, when the branch tube is smaller than the run tube.
Bent tubes can be fixed to the table, too.
T-DRILL
HFT-2000 feed table is a manually operated device to be used in conjunction with
T-DRILL T-35 or T-60 collaring machines. Also collaring of stainless steel is
possible, when the branch tube is smaller than the run tube.
The standard version is for 79 “ long tubes. The capacity of the basic HFT
can be increased with optional 79” extension modules that easy to install. Basic
HFT can be extended with as many modules as needed.
With the HFT 2000
you can produce twenty 1 1/8" outlets in less than ten minutes without moving
the tube. The device can be used also for short tube lengths by furnishing the
feed table with corresponding clamping systems. T-60 HFT is capable for
producing collars 3/8" - 2 1/8" in run tubes from 5/8" -4". More details can be
found in the capability chart in the 'Technical Information'.
T-DRILL collars give the most reliable tube joints being used with the most
extreme applications. Use T-DRILL - no leakages.
The following additional modules are available optionally:
The rotary module is an option,
when making collars with different angles. The standard rotary module has
intervals of 15 degrees. Any other degree interval is possible when using a
different template. The templates are easy and quick to change when needed.
- Measure Module
The optional measure module increases the usability of HFT, when
collaring individual mixed size products. The measure module shows the distance
in a digital display. The module can be fixed easily to the collaring unit with
a locking knob.
- IPC Module
Hand Feed Table (HFT) basic unit can be equipped
also with a pneumatic operated Internal Punching Unit (IPC), for producing 6, 8,
10 or 12 mm “IPC-collars” with fixed tooling.
Internal punching is a
special case branching method when the wall thickness of the tube is too heavy
for traditional collaring.
IPC module can be equipped as a “stand-alone” solution with Hand Feed
Table and it will utilize mechanics from the table including two axial templates
for different manifold set-up. IPC unit requires always tooling for specific
size. 
In case that also T-DRILL T-35 or T-60 unit is placed in the same
table, both solutions will work parallel at the system benefiting the most
optimal collar. In case some special collar size is required, T-DRILL unit can
be adjusted in a few minutes to perform required size.
Max wall thickness according to capacity chart for copper (T-35 range
inside rectangle)
